Three Crowns Electric

Electric Heating

Fort Collins, CO

Larimer County • Licensed & Insured

50% of our profit back if we're over time or over budget.

Call Book Text

Trusted by Colorado Homeowners

Google Guaranteed Three Crowns Electric, LLC BBB Business Review Nextdoor Neighborhood Fave 2025 Winner Yelp 5 Star Rating Windsor Area Chamber of Commerce Member

Electric Heating • Fort Collins

Electric Heating in Fort Collins, Colorado

Fort Collins homeowners and businesses count on Three Crowns Electric for electric heating. We've been serving Larimer County since 2002 — our trucks are on Fort Collins streets every week, from Colorado State University and Old Town Fort Collins to the neighborhoods that need us most.

Electrical wiring and circuits for electric heat — baseboard heaters, in-floor radiant heat, heat pump hookups, and dedicated circuits for electric water heaters and furnaces. We don't sell HVAC equipment, but we wire it, circuit it, and size the panel for it.

We cover every Fort Collins neighborhood — Old Town, Midtown, Campus West, Harmony Corridor — and zip codes 80521, 80524, 80525, 80526, 80528. Whether you're in a 1970s ranch or a brand-new build, the scope is the same: diagnosis first, written quote second, work starts only when you say go.

Common in Fort Collins

What We Handle in Fort Collins

  • Heat pump install with no existing circuit at the condenser
  • Replacing a gas water heater with an electric one
  • Adding radiant floor heat to a bathroom remodel
  • Baseboard heat in a basement finish
  • Electric furnace retrofit on an older home

Electric Heating in Fort Collins

$500–$3,000

Pricing for electric heating in Fort Collins depends on your home's setup, panel condition, and scope of work. Free estimates — written on paper, no pressure.

50% of our profit back if we go over the quoted timeline or bust the estimate. In writing.

Frequently Asked Questions

Common questions about Electric Heating in Fort Collins.

Can you wire a heat pump my HVAC contractor is installing?

Yes — we do this all the time. The HVAC contractor handles refrigerant and equipment; we handle the circuit, breaker, disconnect, and whip from the panel to the condenser. We coordinate schedules so the circuit is ready before they show up to set the unit.

How much does it cost to add a circuit for a heat pump or electric water heater?

Typical range is $500 to $1,500 for a single dedicated circuit depending on the run length, the breaker size, whether the panel has a free slot, and whether the unit is inside or outside. We quote the circuit as its own line item so you know what the electrical costs versus the equipment.

Do I need a panel upgrade to add a heat pump?

Sometimes. A 3-ton heat pump usually needs a 30A or 40A circuit. If your existing 100A panel is already running electric range, electric water heater, and a dryer, the new load may push you over. We do a load calculation first and tell you honestly whether an upgrade is needed or whether we can fit the circuit as-is.

Can you wire radiant in-floor heat?

Yes — we wire the electric mat or cable and the thermostat, and coordinate with the floor installer on timing. The tile or flooring goes on top, and the thermostat sits on the wall at the height you want. GFCI protection is built into the circuit.

Get in Touch
With Our Team

We make it easy to connect with a licensed electrician who understands your needs. Reach out by phone, email, or by filling out the simple form below — and experience the Three Crowns Electric difference.

(970) 645-3114 Admin@Threecrownselectric.Com
Monday – Friday 7:30 am - 5 pm

Contact us

Leave your contact details and we will call you back.